Loading Batteries; Attaching To The Camera - Olympus FL-900R Bedienungsanleitung

Readying the Flash
Preparing a Battery (Sold Separately) Preparing a Battery (Sold Separately)
Choose from the below batteries:
AA (R6) NiMH batteries (× 4)
• AA (R6) manganese batteries cannot be used.

Loading Batteries

Loading Batteries
1 Open the battery compartment cover.
2 Insert the batteries with correct +/–
polarity.
Close the battery compartment cover.
3

Attaching to the Camera

Attaching to the Camera
Confi rm that both the camera and electronic fl ash are off. Attaching or removing
the electronic fl ash while either the fl ash or the camera is on may result in
malfunction.
• Dirt or water on the contacts can cause malfunction. Remove dirt, water, and
other foreign matter before attaching the unit to the camera.
1 Keeping the latch release pressed, slide the latch
in the direction opposite to that shown by the
[LOCKD] arrow to undo the latch ( 1 ).
2 Slide the fl ash into the hot shoe until it clicks
securely into place ( 2 ).
3 Slide the latch to the [LOCKD] position ( 3 ).
• To remove the fl ash, undo the latch as described in Step
1 and slide the unit from the camera.
24
EN
AA (R6) alkaline batteries (× 4)
1
2
3