Edy EDHC8055 Gebrauchsanleitung Seite 81

Before using
Using your appliance
● Before using this appliance for the first
time, you should use it
instructions .
1. Hold the two sides of the water tank
tightly, then pull up the water tank by
shaking up and down.
2. Unscrew the head, then clean it and the
inside of water tank.
①
②
dispenser part
Assembling
Before assembling, please drain the water
●
inside the tank, and check whether the
washer is reversed or not.
1.Insert the head into the hole.
2.Fit the tank along the guides on the
door.
3.Press down on the two side of the tank.
4.When you hear a click sound, that
means the installation is completed.
①
Slot
Guide
③
Warning!
1.Be careful not to press on the head.
2.When fitting the water tank, ensure the
head inserted into the hole first.
based on following
②
④
Filling water
1. Open the water supply inlet cover from
the left side.
2.Fill the water.
Caution!
●
Fill with water up to 2.5L (which is
suggested), and not above the level.
Otherwise, it may overflow when the lid is
close.
● Other beverage(milk,juice,carbonated
beverage etc) is not suggested to be
used than potable water .Especially
beverage including grain must not be
used (may result in failure).
●
Hot water can not be filled into the water
tank directly.
Warning!
Don't touch other parts of the appliance
when filling water, it may cause the water
leakage.
Dispensing water
1. Make sure the cover of the water tank
is fitted on.
2. Close the fridge door and check the
dispenser.
unlock Lock
Before you dispense the water, make sure
the lock device is on left side,it is meaning
unlock situation.
Warning!
The lock is defined as "child lock".
Don't push the dispenser lever forward
strongly, when the dispenser is on right
side, it is meaning lock situation, it may
damage the mechanism.
14