Edy EDHC8055 Gebrauchsanleitung Seite 79

Operation
Starting up and temperature regulation
Insert the plug of the connection lead into
the plug socket with protective earth
c o n t a c t . W h e n t h e r e f r i g e r a t o r
compartment door is opened, the internal
lighting is switched on. After the fridge has
been placed in position, wait for 5 minutes
before electricity is supplied. Don't store
anything until the temperature inside the
fridge becomes low enough.
The temperature selector knob is located
on the top of the refrigerator compartment.
Setting 0 means:
Off.
Clockwise rotate the knob to turn on the
appliance.
Setting 1 means:
Highest temperature, warmest setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
Important! Normally we advise you select
setting of 2 or 3 0r 4, if you want the
temperature higher or colder please turn
the knob to warmer or colder setting
accordingly. When you turn the knob to
colder which can lead to the more energy
efficiency-Otherwise, it would result the
energy-consuming.
Important! High ambient temperatures
(e.g. on hot summer days) and a cold
setting (position 6 to 7) may cause the
compressor to run continuously or even
non-stop!
Reason: when the ambient temperature is
h i g h , t h e c o m p r e s s o r m u s t r u n
continuously to maintain the low
temperature in the appliance.
Changing the light bulb
Warning! If the light bulb is
damaged. DO NOT CHANG IT BY
THE USER!
Changing the light bulb carry out by
inexperienced persons may cause injury
or serious malfunctioning. It must be
replaced by a qualified persons in order to
avoid a hazard. Contact your local Service
Force Center for help.
Before changing the light bulb, switch off
the appliance and unplug it, or pull the
fuse or the circuit breaker.
Light bulb data: 220-240 V, LED
MAX.1.5W.
To switch off the appliance, set the
temperature regulator to position "0".
Unplug the mains plug.
Press the light bulb cover, and slide it
backwards.
To change the light bulb, undo the screw.
Remove the bulb fixed block, change the
defective light bulb.
Refit the bulb fixed block, the light bulb
cover and the screw.
Put the refrigerator back into operation.
Bulb fixed block
Bulb cover
Screw
Control Box
12
Bulb