Edy EDHC8055 Gebrauchsanleitung Seite 77

11. Unscrew the bottom hinge axis and
remove it to the hole which is side by side
and screw it.
washer
Note: washer may stick to lower door
12.Replace the lower hinge part to the left
side and fixing it with the special flange
self-tapping screws. Replace the front feet
fixed board to another side and fixing it
with the special flange self-tapping
screws. Install the adjustable bottom feet
parts.
Lower hinge part (left)
13.Transfer the lower door to the property
position, adjust the lower hinge part, make
the hinge axis into the lower hole of the
lower door, then tight the bolts.
14.Upturn the middle hinge part the
direction 180 degree, transfer it and adjust
its position, make the middle hinge axis
into the upper hole of the lower door, tight
the bolts.
front feet fixed board
15. Transfer the upper door to the
appropriate position. Secure the door's
level, make the middle hinge axis into the
lower hole of the upper door.
16. Transfer the upper hinge part and
make the upper hinge axis into the upper
hole of the upper door, and adjust the
position of the upper door (please support
the upper door with your hand when doing
it), fixing the upper hinge part with the
special flange self-tapping screws.
upper hinge part
17. Install the screw hole cover on the top
right corner of the refrigerator. Install the
upper hinge cover (which is in the plastic
bag) on the left corner. Put the other
upper hinge cover into the plastic bag.
10
middle hinge part
selftapping screws