Edy EDHC8055 Gebrauchsanleitung Seite 76

9
6. Place the upper door on a smooth
surface with its panel upwards. Loose
screw ② and part ①, then Install
them to the left side and tighten securely.
7. Unscrew the two special flange self-
tapping screws which are used for fixing
the middle hinge part, then remove the
middle hinge part that hold the lower door
in place.
NOTE: When removing the door, watch
for washer(s) between the center hinge
and the bottom of the freezer door that
may stick to the door. Do not lose.
middle hinge part
special flange
selftapping screws
① Stop block
② Self-tapping screw
①
②
8. Place the lower door on a smooth
surface with its panel upwards. Loose
screw ② and part ①, then Install
them to the left side and tighten securely.
9. Change screw hole covers on middle
cover plate from left to right (as shown in
figure below).
screw hole covers
10. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts, and
remove the front feet board and the lower
hinge part by unscrewing the special
flange self-tapping screws.
①
②
③
④
① Lower hinge part (right)
② Front feet fixed board
③ Adjustable bottom feet part
④ Self-tapping screws
① Stop block
② Self-tapping screw
①
②
screw hole covers