Velleman CTC1000 Bedienungsanleitung Seite 30

During an alarm, to stop the siren and clear the display:
 Key in your pin code and press OK.
If the pin code is correct, the alarm sounding will be stopped.
If you press any key other than the first digit of your pin code, the screen will prompt you to enter your pin
code.
Reporting
The reporting behaviour varies depending on when you stop the alarm
 Before reporting has started
 While reporting is on-going
 After reporting was finished
Alarm stopped before reporting has started
The system will not send any alarm reports.
1. The display will show the device that triggered the alarm with its zone number.
2. Press OK.
If multiple alarms have been raised, the control panel continues displaying the 2nd alarm event with 02). at
the beginning of the 2nd line.
3. Repeat pressing OK until the display shows:
[meaning: system did not reach any phone numbers]
4. Press OK.
The display returns to Alarm off.
Or press to review all events.
Alarm stopped while reporting is on-going
1. The display will show the device that triggered the alarm with its zone number.
2. Press OK.
If multiple alarms have been raised, the control panel continues displaying the 2nd alarm event with 02). at
the beginning of the 2nd line.
3. Repeat pressing OK until the display shows:
[meaning: system did not reach any phone numbers]
4. Press OK.
The display returns to Alarm off.
Alarm stopped after reporting was finished
1. The display will show the device that triggered the alarm with its zone number.
V. 01 – 12/06/2013
CTC1000
30 ©Velleman nv