Velleman CTC1000 Bedienungsanleitung Seite 20

4. Press OK again to finish.
To add a PIR sensor
Assuming you have assigned a zone number (see section 9.2):
1. Use the up and down arrows to select a working mode and press OK.
For details about the available working modes, see section 9.3.
2. Provide a zone name.
If you do not want to use a name, leave this field blank.
3. Press OK to confirm installation.
4. Press OK again to finish.
To add an external PIR Sensor
Assuming you have assigned a zone number (see section 9.2):
1. Use the up and down arrows to select a PIR type and press OK.
Regular: device will be added as an ordinary PIR
o
External: device will be added as an external PIR.
o
2. Use the up and down arrows to select a working mode and press OK.
For details about the available working modes, see section 9.3.
3. Provide a zone name.
If you do not want to use a name, leave this field blank.
For information about entering text, see section 17.
4. Press OK to confirm installation.
5. Press OK again to finish.
To add a remote control
Assuming you have assigned a zone number (see section 9.2):
V. 01 – 12/06/2013
CTC1000
20 ©Velleman nv