Technical Information - IKEA RENGÖRA Bedienungsanleitung

ENGLISH
Problem
The appliance does
not drain the water.
The salt indicator con-
tinues to stay on after
the replenishment of
the salt container.
After the checks are completed, activate the
appliance. The programme continues from
the point of interruption.
If the problem occurs again, contact the
service.
If the display shows other alarm codes, con-
tact the service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses
and dishes
•• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
•• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
•• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector to
a higher position.

Technical information

Dimensions
Electrical connection
Water supply pressure
Possible cause
The anti-flood device is on.
There are water leakages in
the appliance.
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
This can occur when you are
using salt that needs more time
to dissolve.
There is no unwanted effect on
the performance of the appli-
ance.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Possible solution
Close the water tap and con-
tact the service.
Clean the sink spigot.
Make sure that the position of
the hose is correct.
If after 3 or 4 programmes, the
salt indicator continues to stay
on, contact the service.
•• The quality of the detergent can be the
cause.
Dishes are wet
•• The programme is without a drying
phase or with a low temperature drying
phase.
•• The rinse aid dispenser is empty.
•• The quality of the rinse aid can be the
cause.
Refer to ‘'HINTS AND TIPS’' for other
possible causes.
596 / 818 - 898 / 555
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
15