Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita 9741 Bedienungsanleitung

ENGLISH
1-1. Wing nut
1-2. Front roller
2-1. Switch trigger
2-2. Lock button
3-1. Spindle
3-2. Wheel
3-3. Output shaft

SPECIFICATIONS

Wheel size (Diameter x Width)
No load speed (min
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for removing paint with slit paper
wheel and fine metal cleaning with wire brush wheel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 88 dB (A)
sound power level: 99 dB (A)
Uncertainty: 3 dB(A)
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN60745.
For Model 9741
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Yasuhiko Kanzaki CE2005
Explanation of general view
3-4. Hex wrench
4-1. Notch
4-2. Wheel
4-3. Spindle
4-4. Pin
5-1. Dust port
5-2. Cover plate
Model
-1
)
Net weight
Safety class
2
.
ENE053-1
000087
ENF002-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

SPECIFIC SAFETY RULES

ENG005-2
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to sander safety rules. If you use this tool unsafely
or incorrectly, you can suffer serious personal
injury.
1. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
2. Always
Ordinary eye or sun glasses are NOT safety
glasses.
ENH101-5
3. Inspect for and remove foreign matter such as
nails, screws, etc. from the workpiece surface
before operation.
4. Secure the workpiece firmly.
5. Do not wear gloves during operation.
6. Hold the tool firmly with both hands.
7. Keep hands away from rotating parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
3
5-3. Joint
6-1. Grip
6-2. Handle
7-1. Limit mark
8-1. Screwdriver
8-2. Brush holder cap
9741
100 mm x 120 mm
3,500
310 mm x 185 mm x 182 mm
4.2 kg
/II
Director
use safety glasses or goggles.
GEB022-1