Functional Description; Operation; Maintenance - Makita 9741 Bedienungsanleitung

9. Never attempt to use with the tool held upside
down in a vise, etc.
10. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
11. Use of this tool to sand some products, paints
and wood could
containing hazardous
appropriate respiratory protection.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting front roller
Fig.1
The front roller allows you to apply uniform pressure to
the workpiece. To adjust the front roller, set the tool on a
flat surface and loosen the wing nut. Adjust the front
roller up or down until the clearance distance (D) is
about 2 mm. Tighten the wing nut securely.
Switch action
Fig.2
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
expose user to dust
substances.
Installing or removing wheel
Fig.3
To remove the wheel, insert one hex wrench into the end
of the spindle and another hex wrench into the end of
the output shaft. Turn the hex wrench in the output shaft
clockwise while securely holding the hex wrench in the
spindle so that the wheel cannot revolve. Pull the output
shaft out from the wheel. Move the wheel slightly away
Use
from the spindle and remove the wheel from the tool.
NOTE:
The output shaft has a left hand thread.
•
To install the wheel, follow the removal procedures in
reverse. When installing it, be sure to align the notches
in the wheel with the pins on the spindle.
Fig.4
Connecting to dust collector
Fig.5
The use of a dust collector makes sanding operations
clean and dust collection easy. To connect a dust
collector, open the dust port by sliding the cover plate up
and in a clockwise direction. Attach the joint onto the
dust port. Now a dust collector can be connected to this
tool.
CAUTION:
When not using a dust collector, close the dust port
•
opening with the cover plate.

OPERATION

Fig.6
Hold the tool firmly with both hands on the handle and
the grip in front. Place the tool on the workpiece surface
and move the tool gently forward and backward while
applying slight downward pressure.
CAUTION:
The tool should not be in contact with the
•
workpiece surface when you turn the tool on or off.
Damage to the tool or the workpiece surface and
injury to the operator may result.
Apply slight downward pressure only. Excessive
•
pressure may decrease tool efficiency, shorten
wheel service life and possibly gouge the
workpiece surface.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
4