jetStamp graphic 970
1.3. Install PCset graphic Software
Installation is only possible with administrator rights on the computer.
Insert PCset graphic CD into the drive.
f
If the installation programme does not start up automatically, start the file "setup.exe".
f
Observe the installation programme instructions.
f
1.4. Firmware update
The most up to date firmware for the jetStamp graphic 970 can be downloaded from the
REINER website (www.reiner.de).
1.5. Recognising and Removing Interferences
For more information, see the online help of the PCset graphic software, or the enclosed CD.
Contact
Ernst Reiner GmbH & Co. KG
Baumannstr. 16
78120 Furtwangen / Germany
Phone:
+49 7723 657-0
Fax:
+49 7723 657-200
Email:
reiner@reiner.de
www.reiner.de
© 2015 Ernst Reiner GmbH & Co. KG
All rights reserved. Translation, reprint and other reproduction of these operating
instructions, even in parts and no matter the form, shall require our express written consent.
We reserve the right to make content changes to these operating instructions without notice.
These operating instructions were drawn up with care; however, we cannot assume any
liability for any defects and errors or resulting consequential damage.
GB
16