Install The Hardware - Axis Q6042-C PTZ Installationshandbuch

Function
0 V DC (-)
DC output
Configurable
I/O 1 (Input or Output)
Configurable
I/O 2 (Input or Output)

Install the Hardware

NO TICE TICE
NO NO TICE
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required.
All cables connecting the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their specific use. Make sure that
the network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Regulatory Information on page 2.
• Mount the product with the dome cover facing downward.
• The product has a dehumidifying membrane for maintaining low humidity levels inside the
dome. To avoid condensation, do not disassemble the product in rain or damp conditions.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
The Axis product can be installed with the cables routed through or along the wall or roof.
In areas where the temperature is above 60 °C (140 °F), the product shall be placed in a restricted
access location.
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
• Remove the protective packaging between the camera and the sunshield before installing
the camera.
• A smoked dome cover can be purchased from your Axis reseller. To replace the dome
cover, see page 24.
• A standard or high capacity SD card (not included) can be used to store recordings locally
in the product. To install an SD card, see page 25.
Pin Notes
1, 4, 6
2
Power out
3
Digital input
Digital output (transistor –
open collector)
5
Digital input
Digital output (transistor –
open collector)
23
AXIS Q60 Series
Specifications
0 V DC
12 V DC, 50 mA
0 to max 30 V DC
0 to max 30 V DC,
open drain, 100 mA
0 to max 30 V DC
0 to max 30 V DC,
open drain, 100 mA