In Addition To The Above Rules, These Additional - Ryobi RBC42FSBO Bedienungsanleitung

● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
● removing blade
● installing blade
WARNING
Never use cutting means or attachments, which are
not specified by Ryobi in this manual. This includes
the use of metal multi-piece pivoting chains and flail-
blades. These items are known to break up during use
and present a high risk of serious injury to the operator
or bystanders.
WARNING
Inspection after dropping or other impacts: Thoroughly
inspect the product and identify any problems or
damage to it. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
GRASS TRIMMER SAFETY WARNINGS
■ Replace the string head if cracked, chipped, or
damaged in any way. Be sure the string head is
properly installed and securely fastened. Failure to do
so can cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length for safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
repaired or replaced by an authorised service facility.
■ Make sure the head attachment is properly installed
and securely fastened.
English (Original instructions)
■ Make sure all guards, deflectors, handles, bolts, and
■ Do not modify the product in any way. This may
■ Use only the manufacturer's replacement line in the
■ Never operate the product without the cutting
■ Maintain a firm grip on both handles while trimming.
BRUSHCUTTER SAFETY WARNINGS

■ In addition to the above rules, these additional

■ Use heavy-duty gloves while installing or removing the
■ Do not attempt to touch or stop the blade when it is
■ A moving blade can cause severe injury. Maintain
■ Replace any blade that has been damaged. Always
■ Use only the manufacturer's replacement Tri-Arc™
■ Never cut any material over 13 mm diameter for Tri-
■ Your brushcutter is fitted with a harness. Carefully
■ Identify the quick release mechanism and practice
■ Cover the blade with the blade protector before storing
■ Exercise extreme caution when using the blade with
16
fasteners are properly and securely attached.
increase the risk of injury to yourself or others.
cutting head. Do not use any other cutting attachment.
attachment guard in place and in good condition.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
instructions are appropriate when using the product in
brushcutter mode.
blades, they have sharp edges.
rotating.
proper control of the product with both hands until the
blade has completely stopped rotating.
make sure the blade is installed correctly and securely
fastened before each use.
blade or saw blade. Do not use any other cutting
attachment.
Arc™ blade and over 40 mm diameter for the saw
blade.
adjust the harness to fit comfortably and help to
support the weight of the product at your right side.
using it before you start using the product. Its
correct use may prevent serious injury in case of
an emergency. Never wear additional clothing over
the harness or otherwise restrict access to the quick
release mechanism.
the product, or during transportation. Always remove
the blade protector before using the product. If not
removed, the blade protector could become a thrown
object as the blade begins to turn.
the product. Blade thrust is the reaction that may occur
when the spinning blade contacts anything it cannot
cut. This contact may cause the blade to stop for an