For The Installer; Component Location - Nibe UKV 40 Benutzer- Und Installateurhandbuch

For the Installer

GENERAL
UKV 40 has several different areas of use.
UKV 40 can be used during external control of the
heating system. The heat pump then charges UKV 40
with floating or fixed condensing. The external control
function controls the heat distribution from UKV 40 to
the consumer.
If the flow to the heating system can be restricted using
radiator thermostats, for example, install a UKV 40 as
an intermediate tank. This ensures a secure flow for the
heat pump.
UKV 40 also allows a greater flow to the heating system
than across the heat pump.
In some installations, so-called heating clicks occur as
a result of movements during changes in temperature.
To eliminate temporary changes in temperature, and
thereby prevent heating clicks, install a UKV 40 after the
heating installation.
UKV 40 can also be used to increase the system volume
and thereby prevent malfunctions.
The accumulator tank consists of a condensation-insu-
lated steel vessel with polyurethane insulation. Outer
cladding in white, powder-coated sheet metal with ends
of durable plastic.
The accumulator tank is designed and manufactured for
a maximum cut-off pressure of 6 bar.
The working temperature is +4 to +95 °C.
TRANSPORT
UKV 40 should be transported and stored in the dry.
ASSEMBLY
UKV 40 has to be installed vertically suspended on the
wall.
The accumulator tank must be installed in a dry area at
a temperature that does not drop below 0 °C (frost-free).
MOUNTING
UKV 40 has to be installed vertically suspended on the
wall. First install the enclosed mounting bracket on the
wall, then suspend UKV 40 from the bracket.
UKV 40 | GB
SUPPLIED COMPONENTS
Suspension bracket.

COMPONENT LOCATION

UKV 40
Designa- Name
tion
UL2 Holes for wall bracket
PF3 Serial number plate
PF3
UL2
15