For The Installer - Nibe VPA 200/70 Benutzer- Und Installateurhandbuch

For the Installer

General
VPA 200/70 is a series water heater, which is suitable for
connection to heat pumps, gas or oil-fired boilers.
The water heaters consist of a hot water tank and an
enclosing, double walled sheet steel jacket. The water
tank is lined with copper to prevent corrosion.
The water heater is designed and manufactured for a
maximum cut-off pressure of 10 bar. Maximum permit-
ted temperature is 95 °C.
Maximum working pressure in the double jacket is 3 bar.
The insulation is polyurethane, which provides excellent
heat insulation. The outer shell of VPA 200/70 is powder-
coated, white steel.
VPA 200/70 is equipped with an immersion heater
socket and submerged tube for control of hot water
heating.
Transport
VPA 200/70 should be transported and stored vertically
in a dry place. The VPA 200/70 may, however, be care-
fully laid on its back when being moved into a building.
Assembly
The water heater is only designed for upright installation.
Unscrew the water heater from the pallet. Screw the
enclosed plastic feet into the stand
Position VPA 200/70 on a firm base that can take the
weight, preferably on a concrete floor or foundation.
Use the product's adjustable feet to obtain a horizontal
and stable set-up.
20-55 mm
30 - 50 mm
VPA 200/70 | GB
0 R
0
R
H o t w a te r 5 1 °C H M flo w 4 9 (5 0 ) °C
+ 2 0 -2
1 0
R
H o t w a te r 5 1 °C H M flo w 4 9 (5 0 ) °C
0 -2 + 2
1 R 0
17