Electrolux EUF2740AOW Benutzerinformation Seite 26

26 www.electrolux.com
Problem
The appliance is noisy.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
Water flows on the floor.
Temperature cannot be set. The FastFreeze or Shop-
Door is misaligned or inter-
feres with ventilation grill.
Possible cause
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze function is
switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
pingMode function is
switched on.
The appliance is not level-
led.
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified electri-
cian.
Check if the appliance stands
stable.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func-
tion".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FastFreeze
or ShoppingMode function".
Refer to "Levelling".