Installation - Zoppas PBM170 Benutzerhandbuch

Installation

The microwave can be fitted in position A, B, C or D:
Position
A
B+C
D
Measurements in (mm)
Installing the appliance
1. Remove all packaging and check carefully for any
signs of damage.
2. This oven is designed to fit into a 360 mm high
cupboard as standard.
When fitting into a 350 mm high cupboard:-
Unscrew and remove the 4 feet from the bottom
of the oven. There are 3 tall feet and 1 short foot.
Replace the 3 tall feet with those provided in the
accessory pack. Do not replace the short foot.
3. Fit the fixing hooks to the kitchen cupboard using
the instruction sheet and template supplied.
4. Fit the appliance into the kitchen cupboard slowly,
and without force. The appliance should be lifted
onto the fixing hooks and then lowered into place.
In the case of interference during fitting, this hook
is reversible. The front frame of the oven should
seal against the front opening of the cupboard.
5. Ensure the appliance is stable and not leaning.
Ensure that a 4 mm gap is kept between the
cupboard door above and the top of the frame
(see diagram).
4 mm
Niche size
W D H
560 x 550 x 360
560 x 300 x 350
560 x 300 x 360
560 x 500 x 350
560 x 500 x 360
4 mm
4 mm
Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of 500 mm
(E) above the worktop and must not be installed
directly above a hob.
• This appliance has been tested and approved
for use near domestic gas, electric and induction
hobs only.
• Sufficient space between hob and microwave
should be allowed to prevent overheating of
microwave oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans when the
microwave oven is operating.
• Care should be taken when attending to the
microwave oven while the hob is on.
21