Warranty - Chicco BEST FRIEND CROSSOVER Bedienungsanleitung

22. To assemble, thread the shoulder straps in the designated
slots (Fig. 23) making sure to leave the vertical seam facing
outward. The shoulder straps can be adjusted according
to your child's size.
23. Slide the crotch strap into the slot in the material as seen
in Fig. 24.
FOLDING AND UNFOLDING THE STROLLER
To fold the stroller, put the handle in the closed position (Fig.
17). It is possible to close the stroller in three different modes:
without the seat, leaving the seat fastened to the frame in either
the forward facing position or the rearward facing position.
FOLDING AND UNFOLDING THE STROLLER WITHOUT
THE SEAT
24. To remove the seat, press the grey buttons located near
the seat's joints (Fig. 25). Fold the stroller by sliding the grey
button (on the transversal tube) outwards whilst lifting up
on the handle (Fig. 26), compacting the frame until you hear
a locking click (Fig. 26A).
25. To unfold the stroller, undo the lock hook (Fig. 1) and turn
the handle upwards until you hear a click. The stroller is
properly unfolded when green is visible in the two openings
shown in figure 26B.
FOLDING AND UNFOLDING THE STROLLER WITH THE
FORWARD FACING SEAT
26. Fold the seat by sliding the grey button outwards whilst
lifting up on the lever located on the upper edge of the
backrest (Fig. 27) and pushing the backrest forwards until
it is fully compact (Fig. 27A). Fold the stroller by sliding the
grey button (on the transversal tube) outwards whilst lifting
up on the handle (Fig. 26), compacting the frame until you
hear a locking click (Fig. 26A). The stroller is now folded with
the seat fastened to the frame (Fig. 28).
27. To unfold the stroller, carry out the operations described in
point 25 and then place the seat into position.
FOLDING AND UNFOLDING THE STROLLER WITH THE
REARWARD FACING SEAT
28. Fold the seat by sliding the grey button outwards whilst
lifting up on the lever located on the upper edge of the
backrest (Fig. 27) and pushing the backrest forwards until
it is fully compact (Fig. 29). Fold the stroller by sliding the
grey button (on the transversal tube) outwards whilst lifting
up on the handle (Fig. 26), compacting the frame until you
hear a locking click (Fig. 26A).
29. To unfold the stroller, carry out the operations described in
point 25 and then place the seat into position.
LEG COVER
(Included only if you purchased the Stroller together with the
BEST FRIEND LIGHT CARRYCOT or the BEST FRIEND COMFORT
CARRYCOT)
The carrycot cover may be also used as leg cover for the stroller
configuration.
30. To fit the leg cover, insert the leg rest in the leg cover
compartment (Fig. 31) and pass the upper fabric strap
over the handle, securing it with the designated buttons/
holes (Fig. 31 A).
USING THE CARRYCOT AND CHILD CAR SEAT ON THE
STROLLER FRAME
The BEST FRIEND LIGHT CARRYCOT, BEST FRIEND COMFORT
CARRYCOT and BEST FRIEND CHILD CAR SEAT can be fastened
to the frame of the CHICCO BEST FRIEND stroller.
First, remove the stroller seat from the frame.
FASTEN/RELEASE THE CARRYCOT
31. To assemble the BEST FRIEND CARRYCOT (LIGHT or COMFORT)
onto the frame, hold the handle in the transport position
(Fig. 32), position the BEST FRIEND CARRYCOT (LIGHT or
COMFORT) on the lateral joints of the stroller with the foot
zone rearward facing. Ease it down on the frame until you
hear a click (Fig. 32A).
WARNING: Before use, ensure that the BEST FRIEND CARRY-
COT (LIGHT or COMFORT) is properly fastened by pulling up
on it (Fig. 32B).
32. To release the BEST FRIEND CARRYCOT (LIGHT or COMFORT)
from the stroller, put the handle in the vertical position
(transport), push the button located at the feet for BEST
FRIEND LIGHT CARRYCOT (button located in the hear area
for the BEST FRIEND COMFORT CARRYCOT) and lift it up
from the frame (Fig. 33).
FASTEN/RELEASE THE CHILD CAR SEAT
33. To assemble the BEST FRIEND CHILD CAR SEAT onto the
frame, hold the handle in the transport position (Fig. 34),
positioning the child car seat on the lateral joints of the
stroller with the foot zone rearward facing. Ease it on the
frame until you hear a click (Fig. 34A).
WARNING: Before use, ensure that the child car seat is properly
fastened by pulling up on it (Fig. 34B).
34. To release the BEST FRIEND CHILD CAR SEAT from the stroller,
put the handle in the vertical position (transport), push the
button located behind the backrest and lift it up from the
frame (Fig. 35).
WARNING: The fastening and releasing operations for the
carrycot or child car seat can be carried out also with your
child inside; however, these operations may be more difficult
to execute with the child's weight.
Pay attention when carrying out the above mentioned op-
erations.

WARRANTY

The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions.
The warranty shall not therefore apply in the case of damage
caused by improper use, wear or accidental events. For the
duration of the warranty on conformity defects please refer
to the specific provisions of applicable national laws in the
country of purchase, where appropriate.
16