Chicco BEST FRIEND CROSSOVER Bedienungsanleitung Seite 15

Repeat the same operation for the other wheel.
WARNING: Before using the stroller, make sure that the wheels
are well secured to the structure.
4. Install the basket, positioning the part with the strips in the
direction of the front tube. Insert the strips into the desig-
nated holes on the frame, fastening them with the specific
snap buttons (Fig. 5).
Secure the central part of the basket to the rear tube with the
respective snap buttons.
Fasten the basket to the central part of the rear tube by securing
it to the two sides with the two snap buttons (A) as seen in Figure
5A. Complete the operation by winding the fabric around the
tube and fastening it with the snap buttons (B) (Fig. 5B).
ASSEMBLY OF THE SEAT: STROLLER CONFIGURATION
The packaging includes the disassembled stroller frame and
closed seat.
5. To fit the seat on the stroller, open it by separating the seat
from the backrest as seen in figures 6 – 6A until you hear the
locking click. Press on the lever found on the backrest to
change the position of the joints (Fig. 6B). It is now possible
to install the seat on the frame. The seat can be assembled
on the stroller in both directions: forward facing and rearward
facing (Fig. 6C).
WARNING: Make sure the seat is installed properly by pulling
it upwards (Fig. 6D).
6. To remove the seat, press the grey side buttons and pull
upward (Fig. 7).
WARNING: Do not remove the seat from the stroller when
the child is inside it.
SEAT ADJUSTMENTS
Once the seat is fitted on the frame, it can be reclined in three
different positions.
7. The entire seat can be reclined by pressing on the lever found
on the upper edge of the backrest (Fig. 8).
LEGREST ADJUSTMENTS
8. It is possible to adjust the leg rest in three positions by simul-
taneously pressing the buttons shown in figure 9.
REMOVABLE HANDLE
The stroller is equipped with removable bumper bar.
9. To remove it, press the buttons located on the sides (Fig. 10).
10. To position and remove the child, unhook the bar from one
side only (Fig. 11).
WARNING: Always fasten the safety harnesses. The bar IS NOT
a device for containing your child.
WARNING: The bar must not be used to lift the stroller with
the child inside of it.
HOW TO USE THE SAFETY HARNESS
11. The stroller is equipped with a retaining system with five
anchoring points, consisting of two shoulder straps, two
adjusting holes, a waist belt and a crotch strap with buckle,
already assembled.
WARNING: To adapt the belts to the body of the child, use
the shoulder straps, passing them through the two adjustment
holes as indicated in Figure 12.
12. After laying the child in the stroller, fasten the belts by
threading first the two forks inside the shoulder strap holes
(Fig. 13) and then insert them inside the crotch strap buckle
(Fig. 13A); adjust the length of the straps, ensuring that they
adhere to the child's shoulders and body correctly.
13. To unfasten the waist belt, press and pull the lateral prong
(Fig. 14).
WARNING: Always use the restraint systems. For the safety of
your child use all five fixing points of the safety harness belts.
PARKING BRAKE
The stroller is equipped with pedal parking brake located on
the right rear wheel.
14. To engage the parking brake, press the pedal downward
with one foot (Fig. 15).
To disengage the parking brake, push the pedal upwards (Fig. 15).
WARNING: Always apply the brakes whenever the stroller is
stopped. Never leave the stroller on a sloping surface with your
child inside it, even if the parking brake is engaged.
WARNING: After engaging the parking brake, make sure the
brakes are properly enabled on both rear wheels.
SWIVEL WHEELS
The stroller has front swivel/fixed wheels.
It is recommended to use the wheels in the fixed mode on
particularly changeable surfaces. The use of the wheels in the
swivel mode is recommended in order to increase the control
of the stroller on a normal road surface
15. To allow the front wheels to swivel, push the lever shown
in Figure 16 towards the outside then repeat this operation
on the other wheel.
To lock the front wheels, push the lever shown in Figure 16A
towards the inside then repeat this operation on the other wheel.
WARNING: Both wheels must always be locked or unlocked
at the same time.
HANDLE ADJUSTMENT
The stroller features a handle that can be adjusted in height,
according to the user's needs.
16. Beginning from the folded position (Fig. 17), pull the handle
gently towards you until you reach the first user position
(Fig. 17A).
The handle can be adjusted to 3 different positions by pressing
the release button located on the centre of the handle (Fig. 17B).
WARNING: Do not use the stroller with the handle in the folded
position (Fig. 17), it must always be used in the user position.
After switching from one position to the other, make sure the
automatic locking mechanism is properly engaged.
HOOD
A hood can be installed on the stroller.
The seat features two joints positioned on the sides of the
backrest for securing the hood.
17. To secure the hood, insert the fastening system in the joints
(Fig. 18). Then, secure the fabric part of the hood using the
zipper located on the frame next to the backrest. (Fig. 18A).
WARNING: The hood must be fixed on both sides of the
stroller. Ensure that the hood is correctly secured into position.
18. To remove the hood, open the zipper on the fabric part
completely and pull up on the joints and hood (Fig. 19).
19. To adjust the hood, pull and/or push the central part (Fig. 20).
RAIN COVER
The stroller is equipped with a rain cover.
WARNING: Use the cover only after having installed the hood.
The rain cover cannot be used on the stroller without the hood;
it may represent a suffocation hazard for the child. When the
rain cover is fitted on the stroller, never leave it exposed to
direct sunlight with the child inside, as the temperature will
rise considerably.
20. To secure the rain cover, completely open the stroller
hood, position the rain cover on the hood then wrap it
around the external tube of the backrest. To complete the
assembly, also wrap the opposite side of the rain cover
around the tube in the foot area (Fig. 21), securing it with
the designated strips. After use, hang the rain cover to
dry (if it is wet) before folding and storing it away out of
the reach of children.
WARNING: Use only the supplied rain cover.
COMFORT KIT
21. There is a comfort kit comprising two shoulder strap pads
(A) and one crotch strap pad (B) (Fig. 22).
15