NovoPress AXI101 Betriebsanleitung Seite 33

• Press the pin into the bolt and keep it pressed. Remove the bolt completely. Release the pin.
• Push the pusher adapter with the inscription 1 onto the guide rod in the direction of the arrow.
• Align the pusher adapter with the guide rod so as to ensure that the cross holes are on the same
axis.
• Lock the pusher adapter in place using bolts.
In order to do this:
Press the pin into the bolt and keep it pressed.
Fully insert the bolt.
Release the pin on the bolt.
To check - pull the bolt forwards. It must not be possible to pull the bolt out.
Warning!
Ensure that the bolt is latched in place.
Non-observance will result in damage to the pusher tool.
• Push the pusher adapter with the inscription 2 onto the guide rod as illustrated in the direction of
the arrow and lock it using the bolt.
Note
Ensure that adaptors with matching nominal widths are installed.
Ensure that the matching nominal widths are lined up.
Ensure that the bolts are latched in place.
Non-observance will result in damage to the pusher tool
• Insert the battery.
Slide the battery onto the tool until it clicks in.
29
AAP101 / AXI101
EN