Dry Vacuum Cleaning; Wet Vacuum Cleaning; Charging The Batteries - Grundig VCH 6130 Bedienungsanleitung

OPERATION _ ________________________________
Wall rack installation
Notes
Install the wall rack
7
power outlet, this allows you to charge the unit
hassle-free.
Make sure that the nearest power outlet is reach-
7
able by the power adapter
Leave sufficient free space above the wall rack
7
so you can easily place the vacuum cleaner on
the rack.
Install the wall rack out of the reach of children.
7
Screws and dowels are included.
7
1
I nstall the wall rack
2
M ark boreholes for the three screws.
Caution
Make sure that you do not drill over wiring, ca-
7
bles or water pipes!
3
D rill the boreholes and insert dowels.
4
S ecure the wall rack
Charging the batteries
1
I nsert the adapter cable
motor unit .
J
2 C onnect the power adapter
power outlet.
– The charge indicator
be off after the battery is fully charged.
– The vacuum cleaner must be turned off while
charging.
– The vacuum cleaner is fully charged after
approx 14 hours and the operating time is 7 to
10 minutes.
Notes
Only recharge the batteries when they are nearly
7
empty. This increases the batteries lifespan.
Charge the batteries at a room temperature be-
7
tween 0°C and 37°C.
To increase the battery's lifespan, charge the bat-
7
teries completely before the first use for approx
.16 hours and discharge it again completely.
near an appropriate
Q
.
P
at the desired wall position.
Q
with three screws.
Q
in the port of the
P K
to an appropriate
P
lights up blue and will
L
The maximum charging time is 24 hours and
7
may not be exceeded.
Dry vacuum cleaning
1 I nsert the filter nozzle
and the sponge filter
.
F
2
P lace the container
that the lock clicks in audibly.
E
3 I f necessary, connect the crevice tool
brush attachment
O
4
T o turn on, move the On/Off switch
position I.
5 T o turn off, move the On/Off switch
position 0.
Wet vacuum cleaning
1
I nsert the filter nozzle
2
P lace the container
that the lock clicks in audibly.
E
3 C onnect the wet nozzle
4 T o turn on, move the On/Off switch
position I.
5
T o turn off, move the On/Off switch
position 0.
6 E mpty the container
vacuum cleaning.
Notes
If the area to be cleaned is poorly lit, push the
7
light button to turn on the light
C
same button to turn off the light.
The capacity of the container
7
for dry vacuum cleaning and 0.15L for wet
vacuum cleaning. Observe the MAX marker
for liquids on the container
The sponge filter
H
7
uum cleaning.
Do not vacuum dry and wet dust simultane-
7
ously. Empty the container
and wet vacuuming.
into the container
F
into the filter nozzle
H
on the motor unit
G J
or
M
to the container .
G
in
A
in
A
into the container
F
on the motor unit
G J
to the container
N
in
A
in
A
immediately after wet
G
. Use the
D
is 0.5L
G
.
G
is not used for wet vac-
between dry
G
ENGLISH
G
so
.
G
so
.
G
15