Charging The Battery; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Grundig VCH 5040 Bedienungsanleitung

OPERATION _______________________________
Wall mount installation
Notes
Install the wall mount
power outlet, this allows you to charge the unit
hassle-free.
Make sure that the nearest power outlet is
reachable by the power adapter
Leave sufficient free space above the wall mount
so you can easily place the vacuum cleaner on
the mount.
Install the wall mount out of the reach of
children.
1
Install the wall mount
position.
2
Mark boreholes for the three screws.
Caution
Make sure that you do not drill over wiring,
cables or water pipes!
3
Drill the boreholes and insert dowels.
4
Secure the wall mount
Make sure that the screws can carry the weight
of the vacuum cleaner and its accessories.

Charging the battery

1
Insert the adapter cable
rear part of the motor unit
2
Connect the power adapter
appropriate power outlet.
– The charge indicator
be off after the battery is fully charged.
– The vacuum cleaner must be turned off while
charging.
– The vacuum cleaner is fully charged after
approx 14 hours and the operating time is 7
to 10 minutes.
Notes
Only recharge the battery when it is nearly
empty. This increases the battery's lifespan.
Charge the battery at a room temperature
between 0°C and 37°C.
near an appropriate
Q
P .
Q at the desired wall
with three screws.
Q
P K
in the port in the
J .
P to an
lights up blue and will
L
To increase the battery's lifespan, charge the
battery completely before the first use for approx
16 hours and discharge it again completely.
The maximum charging time is 24 hours and
may not be exceeded.

Dry vacuum cleaning

1
Insert the filter nozzle
and the HEPA filter
2
Place the container
that the lock clicks in audibly.
E
3
If necessary, connect the crevice nozzle
brush nozzle to the container
O
4
To turn on, switch the On/Off switch
position I.
5 To turn off, switch the On/Off switch
position 0.

Wet vacuum cleaning

1 Insert the filter nozzle
2
Place the container
that the lock clicks in audibly.
E
3
Connect the wet nozzle
4
To turn on, switch the On/Off switch
position I.
5
To turn off, switch the On/Off switch
position 0.
6
Empty the container
vacuum cleaning.
Notes
If the area to be cleaned is poorly lit, push the
light button to turn on the light
C
same button to turn off the light.
The capacity of the container
vacuum cleaning and 0.15L for wet vacuum
cleaning. Observe the MAX marker for liquids
on the container G
The HEPA filter
H
cleaning.
Do not vacuum dry and wet dust simultaneously.
Empty the container
vacuuming.
into the container
F
into the filter nozzle
H
on the motor unit
G
M
.
G
A
A
into the container
F
on the motor unit
G
to the container
N
A
A
immediately after wet
G
. Use the
D
is 0.5L for dry
G
.
is not used for wet vacuum
G between dry and wet
ENGLISH
G
F
.
so
J
or
in
in
.
G
so
J
.
G
in
in
13