Maintenance - DeWalt DCF6201 Bedienungsanleitung

The magazine is designed to drive screws
completely into work piece only. Once screwdriver
is lifted, adjustments to screw must be made by first
removing magazine.
Rotating the Collated Attachment
This attachment has the ability to rotate without
being taken off the drywall screwdriver. To rotate,
grip the top portion with one hand, while holding
the drywall screwdriver with the other then rotate. An
audible "click" indicates the magazine is in each of
the available positions.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often
as dirt is seen collecting in and around
the air vents and housing tracks. Wear
approved eye protection and approved
dust mask when performing this
procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap.
For best performance clean magazine by:
1. Remove advancing mechanism from collated
magazine (see Removing and Installing the
Advancing Mechanism instructions).
2. Remove shoe from advancing mechanism.
3. Remove return spring from magazine.
4. Submerge parts in soapy water for 10 minutes.
5. Remove and thoroughly rinse parts.
6. Allow parts to air dry.
7. Reassemble and continue use.
REMOVING AND INSTALLING THE ADVANCING
MECHANISM (FIG. 5)
CAUTION: The advancing mechanism
is spring loaded. Two hands must
be used to remove the advancing
mechanism. The spring may eject from
the mechanism.
To remove advancing mechanism:
1. Remove collated magazine attachment from
screwdriver.
2. Slightly depress advancing mechanism (d) by
pushing on the shoe (e) with one hand.
3. Keeping pressure on the shoe (e) with the other
hand depress advancing mechanism removal
button (f).
4. Slowly release pressure from the shoe (e) until
the advancing mechanism is out of the collated
magazine.
To install advancing mechanism:
1. With the collated magazine attachment
removed from screwdriver, align the tabs (i)
on the shoe with the slots (j) in the collated
housing.
2. Push in slightly, then align the spring (k) with the
pocket in the advancing mechanism.
3. Push advancing mechanism in until you hear
the "click" of the shoe removal button (f).
NOTE: The lever arm (l) should be in the up
position (as shown in figure 5) before the
advancing mechanism is installed. If in the down
position, the advancing mechanism will be
locked in place.
4. Cycle the advancing mechanism several times
by hand to ensure proper function before
installing it onto your screwdriver for use.
ENGLISH
17