Changing The Display View; Teaching-In To Radio Energy-Saving Controllers - Herz ETKF Bedienungsanleitung

The upper part of the display can be used to show oth-
er values instead of the indoor humidity and the indoor
temperature. The Display button is used to change the
view. The following alternatives are available, depending
on whether or not an outdoor temperature sensor has been
taught-in to the wall thermostat:
No outdoor sensor
Indoor humidity and
temperature
Time and date
You can delete the saved min./max. outdoor temperature
values by pressing and holding down the Display button
for longer than 3 seconds.

12. Teaching-in to radio energy-saving controllers

In order to enable communication between radio com-
ponents, the devices have to be taught-in to one another.
Proceed as follows to allow radio energy-saving control-
lers to be managed via a wall thermostat:
• First of all, the radio energy-saving controller must be set
to teach-in mode. For more information on this, refer to
the operating manual for the relevant device.
• The wall thermostat then needs to transmit a radio signal for
teaching-in purposes. To do this, press and hold down the OK
button on the wall thermostat for longer than 3 seconds.
• "LEA" and the remaining teach-in time (starting at 30
seconds) appear on the display and the wall thermostat
28

11. Changing the display view

With outdoor sensor
Indoor humidity and
temperature
Outdoor and indoor
temperature
Min. and max. outdoor
temperature
Time and date