Operating Instructions; Installing And Charging The Battery; Installing The Microsd Card And Power On; Charging - Nilox 4K30 EVO Benutzerhandbuch

EN

OPERATING INSTRUCTIONS

INSTALLING AND CHARGING THE BATTERY

Slide the battery cover following the direction of the arrows and install the battery.
Use the Micro USB cable to charge the camera. The indicator red light (L3) will flash during the
battery charge. Once the battery charge is complete, the light remains lit.

INSTALLING THE MICROSD CARD AND POWER ON

Insert the microSD card in the slot when the camera is off.
Press the power button and hold it down for 3 seconds to turn the video camera on/off; the indicator
red light (L3) will remain lit.
Note: Use microSD cards with a transfer speed equal to UHS Speed Class 3 (U3) or
higher.

CHARGING

Turn on the video camera and check battery status; if low, charge it.
Either a computer USB port of power adapter (not included) can be used to charge it.
When EVO 4K30 is charged in off status, the red status led will flash slowly. When finished charging,
the red led will remain on.
The charge process inhibits video camera operations.

INSERTING AND REMOVING THE MEMORY CARD

The EVO 4K30 video camera supports TF memory cards with capacity up to 64 GB.
Any type of Micro SD card can be used but we recommend high speed cards to optimise
performance.
• Installation.
1. Make sure the video camera is off.
2 Insert the card in its slot, being careful that it is inserted in the correct direction until a click is
heard.
[Digitare qui]