Folding The Chassis; Seat Unit; Fitting The Seat Unit To The Chassis - KIDDY Evostar 1 Bedienungsanleitung

EN

3.7 Folding the chassis

Important: Remove the seat unit / carrycot / car seat and any adapters
before attempting to fold the chassis and ensure the shopping basket
is empty.
Note: e chassis will not fold unless the handle is in the lowest posi-
tion and seats, carrycots adapters etc. have been removed from the
chassis. Engage the parking brake.
Ensure the handle is in its lowest position. Ensure the front wheels are
unlocked and in the swivel position. Fully rotate the central section
of the handle bar towards you, the hub locks will release ( g. 9, no 1).
Lower the handle towards the oor ( g. 10, no. 2). Lift the carry handle
and lift the chassis upwards to allow the front of the chassis to move
towards the rear of the chassis ( g. 11). Secure the chassis using the
locking hooks ( g. 12).

4. Seat Unit

4.1 Fitting the seat unit to the chassis

Important: Ensure that both the legs are in the same position before
attempting to attach the seat unit to the chassis ( g. 13). Failure to do
so may cause damage to the seat unit.
Insert the seat unit legs into the main housings on the chassis until the
seat locks in place with a click ( g. 14).
WARNING
Ensure the seat unit is locked in place on the chassis
before use.
Note: e seat unit can be used in forward facing or parent facing
modes. Simply attach the seat unit in the same way in your preferred
facing mode.
10