Removing The Seat Unit From The Chassis; Carrycot; Assembling The Carrycot - KIDDY Evostar 1 Bedienungsanleitung

EN
Reach inside the seat back rest and locate the buckles. read through
the opening in the seat back and seat cover, adjust to the correct
height position and re-thread back through the seat fabric and seat
back rest. Ensure the buckles are tted correctly before use.
Adjust the straps to suit the child using the sliders on the harness
( g. 22).
To release the connectors depress the grey button on the buckle
housing, the two connectors will release from the main housing.
WARNING
To avoid serious injury always use a 5 point safety
harness.
Important: Always ensure the parking brake is engaged when placing
and removing children from the vehicle.

4.8 Removing the seat unit from the chassis

Depress the grey buttons on the side of the seat unit ( g. 23, no. 1)
and lift the seat upwards from the chassis ( g. 23, no. 2). Important:
Always remove your child from the seat unit before removing the seat
unit from the chassis.

5. Carrycot

5.1 Assembling the carrycot

Remove the apron and mattress to gain access to the stay bars in the
bottom of the carrycot. Using the tabs, pull the stay bars into the clips
on the baseboard until you hear them click into place ( g. 24). Reposi-
tion the lining and place the mattress back into the carrycot.
Important: Ensure that the stay bars are fully engaged before using
the carrycot.
12