Cleaning The Cabinet - SNOWFLAKE SKF20 Bedienungsanleitung

OPERATING MANUAL
MAINTENANCE
CLEANING AND MAINTENANCE

CLEANING THE CABINET

O
I V
O
R S
V
E S I
E T
A
B R
D
A
Fig. 13
Do not wash the appliance by spraying it with
high-pressure water jets, in particular from a
high-pressure cleaner (Figure 13).
Fig. 15
Remove the front panel with a suitable tool and
clean it, removing any dirt which may have come
out of the cabinet (Figure 5).
Clean the core temperature probe by hand. Use lukewarm water and a neutral soap or cleaning agent with a
biodegradability in excess of 90%. Rinse with water and hygiene solution. Do not use any cleaning agents containing
solvents (e.g. trichloroethylene etc.) or abrasive powder.
ATTENTION: The thermometer probe must not be cleaned with boiling water.
Clean inside the cooling cabinet daily.
Both the cabinet and all the internal components have been designed and shaped
to allow all parts to be easily cleaned. Before defrosting, always take out the internal
plug.
Disconnect at the main switch.
Clean all components (stainless-steel, chromium-plated, plastic or painted parts)
with lukewarm water and mild detergent. Rinse and then dry them without using
sandpaper or chemical solvents (Figure 12).
Fig.12
Never clean the evaporator with a sharp or
abrasive object (Figure 14).
Wash the door seal with plain water and dry it
carefully with a dry cloth. Always wear protective
gloves when doing this (Figure 16).
30
SECTION 4
Fig. 14
Fig. 16