Replacing The Lamp - Electrolux ST230 Benutzerinformation

58 www.electrolux.com
Problem
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door does not open easily. You attempted to re-open
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

7.2 Replacing the lamp

The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Possible cause
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
the door immediately after
closing.
1. Using a screwdriver, remove the
2. Detach the lamp cover in the
Solution
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Make sure that there is
cold air circulation in the
appliance.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable
packaging before storing it
in the appliance.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
screw from the lamp cover.
direction of the arrows.