Data Logger Function "Log - Benning CM 12 Bedienungsanleitung

5.5 Data logger function "LOG"

The data logger function "LOG" allows the automatic storage of series of
measurements with a predefined measuring interval and up to 9,999 measured
values. The measuring interval can be set from 1 s to 600 s. For further proces-
sing, the measured values can be read out later by means of the display J or
via Bluetooth .
®
Use the Cursor key M to select the "LOG" function and press the OK/ENTER
key N to open the "LOG" menu.
Use the Cursor keys M to select the following submenus:
SAVE
LOAD
RATE
Use the Cursor key M to select the "LOG" function and press the OK/ENTER
08/ 2018
Press the OK/ENTER key N to start the data logger function
"LOG". Press the OK/ENTER key N again to stop the storage.
Note:
Any restart will delete all measured values stored in the data
logger (LOG).
Press the OK/ENTER key N to open the measured values
stored in the data logger. Press the Cursor keys M (right/►,
left/◄) to call the storage location number on the display J .
Press the RANGE key 7 to toggle between the storage loca-
tion number and the stored measured value. Press the OK/
ENTER key N to cancel the function.
Press the OK/ENTER key N to set the sampling rate defi-
ning the time interval between two measuring points. Use the
Cursor keys M (right/ ►, left/ ◄) to adjust the sampling from
1 s to 600 s.
Press the OK/ENTER key N to confirm.
The deviation of the timer is less than 3 s per hour.
BENNING CM 12

31