Maintenance - Klarstein 10022086 Bedienungsanleitung

a. Forbid to use the machine in the environment with inflammable or flammable gas, avoid long time
shine by the sunshine.
b. Please do not to put the machine on oblique or unbalanced place. Avoid the machine fall down.
c. Please do not let the air intake or air outlet close to the wall, curtain etc. material object.
Otherwise, will block up the air current.
d. If the water tank has water, please do not slope or knock the machine when you lay up or move
the machine. Please move the machine from the side carefully, to avoid the water overflow.
e. Please do not put some flaming appliance below the wind can blow over. Otherwise produce carbon
monoxide.
f. Long time not use the machine, please empty the water tank. Then let the machine works 10
minutes in the blast model. Cut the power supply after the wetted curtain is dry.
g. If use the socket to supply power, the socket should be accord with Standard IEC33-1. When use
the power wire to supply power, should to install a switch with open spread more than 3mm.
Unplug the appliance during filling and cleaning
Clean the wetted curtain and filter
Pull off the plug, removal the 6 screws on
the shutters. Catch the above of the
shutters by hand. Pull the wetted curtain
above lightly.
Wash the water tank
1. Pull of the plug, removal the screws on the shutters, take down the shutters
2. Wriggle the drainage valve at the bottom by hand.
3. Use softy cloth or brush to wash the chassis
4. Use wet cloth to clean the fouling on the water level sensor.
5. Use brush to clean the fouling on the pump and filter.
Wash cover
Use gentle bowl deodorizer and softy cleaning cloth to wash. (do not use the detergent which can
produce foam, volatile solvent, hard brush to clean. The wrong cleaning can break the machine)

Maintenance

Note: the water pressure can not be
too high when cleaning. Forbid to
use acidic or alkaline detergent to
wash the wetted curtain.
11