Control Board - Klarstein 10022086 Bedienungsanleitung

a. Open the package, get out the machine, put it on a horizontal ground.
b. Open the filler, fill fresh water or connect the tap water pipe with the filler. Please note the water
level can not higher than the "H"scale of the water level of the water tank
c. Check the power supply is the same as the data on the nameplate.
d. Plug the connector plug, press the "on/off"Choose a suit wind speed, the evaporative ventilator
works.
e. "on/off"key
When you connect the power supply, the power pilot lamp is on. Press "on/off"±The machine will
works by "blasf"±Fanblade dynamic pilot lamp and the running pilot lamp will on.
f ."cool"key
On the "Call Waiting" or "blast" model, press the "cool" key, the machine will work by the cooling
model. The cool pilot lamp is on. Press the "cool" key again. The machine will work by the "blast"model,
the cool pilot lamp is off
Note: when the water tank don' t have enough water, the system is working from the cool model to
blast model, cooling pilot lamp is on, no water pilot lamp is on. The buzzer will sound the alarm bell.
g. "wind speed" key
On the blast or cool model, press wind speed key can switch the wind speed. Which have 3 different
wind speed. The wind speed pilot lamp is on.
h."Pendulum wind" key
Press pendulum wind key, the machine will work on pendulum wind model. Press again, the pendulum
wind model will stop.
Note: this machine is suit for indoor use.

Control Board

Operate description
8