Bartscher 285.3051 Installation, Benutzung Und Wartung Seite 33

Substituting the pilot burner nozzle (fig. 13, 14 – pag. 6)
To substitute the pilot burner nozzle, it is necessary to open the door of the compartment, unscrew
the fitting (1) which fixes the gas supply pipe of the pilot (2) and remove the nozzle (3). This must
be substituted with an appropriate nozzle for the type of gas used, shown in table 2 (pag. 9).
Assemble the new nozzle, replace the pipe and tighten the fitting fully.
Gas Pasta Cooker (fig. 15 – pag. 6)
To light the burners of the pasta cooker, proceed in the following way:
- turn the knob (1) from the off position
- press down fully;
- push the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the opening in the combustion chamber;
- light the main burner as desired, going from maximum
To put out the main burner, it is necessary to turn the knob to the right into the on position
put out also the pilot, turn the knob again, into the off position
Electric pasta cooker (fig. 16 – pag. 6)
To heat a tub of the pasta cooker, proceed in the following way::
- turn the knob (1) into the desired position. The green light will light up, showing that the
heating elements are on.
It is advisable to regulate the element to the maximum temperature in order to reach the desired
temperature right away, and to leave it in this position for a few minutes; then turn the knob into
the position desired.
To turn off the pasta cooker, turn the knob back into position 0.
Filling the tub (fig. 17 – pag. 6)
First of all, check that the drainage tap, situated inside the appliance under the combustion
chamber, is closed tightly. After that, turn the water filling knob (1) in anti-clockwise direction; fill
the tub up to the level mark. During the cooking, it is advisable to leave the tap turned slightly on,
in order to keep the right water level and to allow the removal of excess starch through the overflow
device.
Emptying the tub (fig. 18 – pag. 6)
To empty the tub, it is necessary to open the door of the compartment and activate the outlet
valve situated inside by turning the lever (1) in anti-clockwise direction.
INSTRUCTIONS FOR USE
into the on position
Position [N°]
0 Pasta cooker off
1 Maintaining temperature
2 Cooking
3 Starting cooking
Pag. 15
;
to light the pilot burner;
to minimum
.
Use
.
, to