Maintenance - Ikra IBRM 40-Z130 Originalbetriebsanleitung

EN
ENGLISH
DANGER!
Risk of poisoning!
Exhaust gases, fuel and lubricants are toxic.
Inhaling exhaust gases may be fatal!
Use the appliance only outside, never use it in
confined and bad ventilated areas.
Do not operate the unit in closed spaces where
dangerours carbon monoxide gases may accu-
mulate.
TRANSPORT
When transporting the tool by car, it must be positioned
so that it poses no danger, and secured.
STORAGE
The appliance must be stored in a dry place and protected
from frost.
Lock the device in a proper place to protect it from
unauthorised use.
After every work stint, clean the machine thoroughly to
remove all dust and debris, and repair or replace any faulty
parts.
Let the engine cool down, before you store the device in a

MAINTENANCE

Only a regularly maintained and treated appliance can
serve as a satisfactory aid. Insufficient maintenance and
care can lead to unforeseen accidents and injuries.
Repairs and works specified in these Instructions may only
be performed by qualified authorised staff.
DANGER!
Switch the engine off and remove the socket plug
before any work on the engine. Wait until all rotating
parts have stopped and the appliance has cooled
down.
Keep hands away from all cutting edges and moving parts.
Fingers can be pulled into cutting carriage and be cut or
crushed.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body! Never clean
the machine and its components with solvents, flammable
or toxic liquids. Us only a damp cloth making.
26
WARNING
Danger of burns !
Some parts of the appliance get too hot when the appli-
ance is operated. Contacting hot parts of the unit may
cause burns.
• Let the unit cool down after its operation is over.
• Do not touch the exhaust pipe or cylinder. These parts
get extremely hot during operation and stay hot for
some time after the device has been switched off.
Make sure that no petrol escapes during transport. Avoid
damage and injuries.
closed room.
DANGER!
Never keep the unit with petrol in the tank inside a buil-
ding where petrol vapours could get in contact with open
fire or sparks.
After every work stint, clean the machine thoroughly
to remove all dust and debris, and repair or replace any
faulty parts.
Check the collection bag at regular intervals for any wear
and aging.
Clean the ejection opening and cover at regular intervals.
To avoid overheating and damage to the engine, always
keep the cooling air vents clean and free of sawdust and
debris.
Keep all nuts, bolts and screws tight to be sure the equip-
ment is in safe working condition;
The starter rope must be replaced as soon as it shows
signs of wear.
The carburettor has an optimised setting 'ex works' . If any
further adjustments should be required contact your
competent customer service.
Use only original accessories and original spare parts.
Using other spare parts can result in accidents/injuries of
the user. The manufacturer will not be liable for any such
damage.
Please contact our service department if you need acces-
sories or spare parts.