Nederman FlexPAK800 Bedienungsanleitung Seite 33

GB
Adjustment of time and date
Mo 09:00
2004-01-29
ESC
Choose Set Clock with
5
Stop
Set Param
>
Setup..
Prg Name
ESC
1. The cursor shows the day of the week . The charac-
ter flashes when selected.
2. Change weekday with
3. Move the cursor to the next position with
4. Make any other necessary setting as in 2 and 3
above.
5. Confirm the change with OK.
Set Clock
>
Mo 15:30
YYYY-MM-DD
2003-01-27
ESC
Adjustment of parameters
Stop
>
Set Param
Set Clock
Prg Name
ESC
Choose parameter with
H-Meater
>
MI = 2000h
MN = 2000h
OT = 0h
ESC
Adjustable parameter for the running time, for more
information, see page 7
MI can be changed when another service interval is
required.
1. Press OK.
2. Step with or to the character to be changed.
3 4
3. Select an appropriate value with
4. Confirm the change with OK. MN is the time remain-
ing until the service alarm is activated.
OT is the total running time since the system was
started.
6
OK
PLC-2
or press OK.
6
OK
PLC-3
or .
5 6
or
3
OK
PLC-4
OK
PLC-5
or press OK.
5 6
OK
PLC-6
or .
5 6
The following WeekTim settings are example of
adjustments to the weekly timer´s default setting,
see page 7 for more information.
WeekTim
D = MTWTF- -
On = 07:00
Off = 12:00
Setting weekly time 1, Monday - Friday mornings.
1. Press OK.
2. D = MTWTF are the weekdays the setting is to apply
to. Move the cursor to the weekday to be changed
with or
3 4
3. Activate the appropriate weekday with
4. Step forward with
5. Select an appropriate value with
6. Step forward with
.
4
changed, to set the ON time.
7. Select an appropriate value with
8. Proceed until the time you want is shown.
9. Repeat the same procedure for the OFF time.
10. Confirm the changes with OK.
WeekTim
D = MTWTF- -
On = 13:00
Off = 16:00
Setting weekly timer time 2, Monday - Friday after-
noons.
The settings are made according to previous section.
WeekTim
D = -----SS
On = --:--
Off = --:--
Settting weekly timer time 3, Saturday - Sunday.
The settings are made according to previous section.
DIR
T = 12:00s
Ta = 00:00
Setting the time before idling.
NOTE! Time should no be adjusted.
1
ESC OK
PLC-8
.
to the next day to be changed.
4
5
to the time character to be
4
5
2
ESC OK
PLC-9
3
ESC OK
PLC-10
ESC OK
PLC-11
GB
or .
5 6
or .
6
or .
6