Rear Panel - SYNQ AUDIO RESEARCH SMP 16.42 Bedienungsanleitung

ENGLISH
9. GROUP OUT (1 to 4 ) JACKS
Unbalanced 1/4" Jack outputs for the signals of GROUP 1-2 / 3-4.
10. MAIN L/R OUTPUT JACKS
Balanced 1/4" Jack outputs. You can use these outputs to connect the power amplifiers for you main speakers, or you
can use them when you wish to record the signal that is also influenced by the main output faders.
11. CONTROL ROOM OUTPUT JACKS
These unbalanced 1/4" Jack outputs are controlled by the
used to connect a monitoring system.
NOTE::The signal monitored by these outputs is selected by the settings of the LEVEL METER SIGNAL SWITCHS, the
TAPE IN switch, and the PFL switches on the input channels.
12. PHONES JACK
Stereo headphones connector.
NOTE:
The signal monitored by these jacks is selected by the settings of the LEVEL METER SIGNAL SWITCHS, the TAPE IN
switch, and the PFL switches on the input channels.

REAR PANEL

1. POWER SUPPLY CONNECTOR
Connect the included power supply here. Replace this power supply only with exactly the same type number.
Use of a different adaptor may result in fire or electric shock.
2. POWER SWITCH
Used to switch the mixer on/off. We strongly advise to set the master output faders of the mixer and the gain
controls of your amplifier to zero before you switch the mixer on or off
.
3. MAIN L/R OUTPUT.
Used to connect the master output (Main L/R) of the mixer to a power amplifier (or other equipment)
4. USB PORT
The built-in stereo USB audio interface allows you to connect your mixer to a PC for recording or playback.
Virtually any digital recording software can be used.
The PC/Mac will detect your mixer as a sound card, so normally no drivers are needed. This means also you
will be able to use the standard audio interface controls in the MAC or Windows operating system to make all
the settings.
Getting Started with Windows XP
The first time you plug the mixer into a USB port, Windows will install the universal drivers for that port. A
balloon tip will pop up, telling you it has found the USB Audio codec.
SYNQ 9/117
®
OPERATION MANUAL
CTRL ROOM /PHONES CONTROL and are generally
SMP16.42
ENGLISH
When the installation is ready, the message "Your new hardware is installed and ready to use" will appear
Most of the time, you'll want the output volume from the computer at its maximum position, but sometimes
the default setting is much lower, what makes the output level too low. The volume can be increased in
several ways. The simplest is to click the loudspeaker icon (figure 3) in the system tray and drag the slider to
the top
If the icon is not there, the volume can be changed by going to Control Panel and opening Sounds and Audio
Devices.
SYNQ 10/117
®
OPERATION MANUAL
SMP16.42