Dometic M55LX Bedienungsanleitung Seite 17

PerfectView M55LX, M75LX
•
To prevent damage to the cables, when laying them ensure that there is always sufficient
distance to vehicle components which can become hot (lights, heaters, ventilators etc.).
When laying the cables (fig. 3, page 3), make sure:
•
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d, page 7)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green cable (7) to
the positive cable of the reversing light.
I
NOTE
If voltage is present in the green cable (7), the reversing camera will be activated
automatically. The reversing camera has priority.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the following
control cable to a positive cable of the indicator:
– white cable (8), blue cable (13)
I
NOTE
If voltage is present in this control cable, the video input CAM2 and CAM3 will be
activated.
EN
Installing the LCD monitor
17