Hilti TE 700-AVR Original Bedienungsanleitung Seite 22

Trouble or fault
The breaker doesn't start.
No hammering action.
The service indicator lights
red.
The service indicator blinks
red.
The breaker switches itself off
while running.
The breaker doesn't achieve
full power.
The chisel cannot be released
from the chuck.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
18
Possible cause
Interruption in the electric supply.
The generator is in sleep mode.
Damage to the power tool or ser-
vice limit time reached.
The power tool is too cold.
Chuck not sufficiently greased.
Damage to the power tool or ser-
vice limit time reached.
The overheating prevention cut-out
has been activated.
The voltage provided by the elec-
tric supply is too high.
The overheating prevention cut-out
has been activated.
Power reduction is active.
The extension cord is too long or
its gauge is inadequate.
The voltage provided by the elec-
tric supply is too low.
The chuck is not pulled back fully.
Action to be taken
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
Switch the tool off and then on
again.
▶ Have the product repaired by
Hilti Service.
▶ Bring the tip of the accessory
tool into contact with the
working surface, switch the
power tool on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Inject 1-2 strokes of grease from
the dispenser into the chuck.
Use genuine Hilti grease. Then
fit the accessory tool and
distribute the grease in the
chuck by pulling the accessory
tool in and out several times.
▶ Have the product repaired by
Hilti Service.
▶ Allow the tool to cool down.
Clean the air vents. Running
under no load is still possible.
▶ Use a different power outlet.
Check the electric supply.
▶ Allow the tool to cool down.
Clean the air vents. Running
under no load is still possible.
▶ Press the power level selector
switch (observe the power level
indicator). Unplug the power
tool from the electric supply and
then plug it back in.
▶ Use an extension cord of an
approved length and / or of
adequate gauge.
▶ Connect the power tool to a
different power source.
▶ Pull the chuck back as far as
it will go and remove the insert
tool.