Installing An Accessory Tool - Hilti DGH 130 Bedienungsanleitung

4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L )
WA
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Vibration emission value, diamond cup wheel (a
Vibration emission value, fine-grinding (a
Uncertainty (K)
5 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Installing an accessory tool

Use only accessory tools approved for a speed at least equal to the rated speed stated on the device.
1. Switch off the power tool.
2. Unplug the supply cord from the power outlet.
3. Clean the clamping flange and the clamping nut.
4. Fit the clamping flange to the arbor.
5. Fit the accessory tool.
6. Tighten the clamping nut until it is seated on the accessory tool.
7. Press and hold down the spindle lock button.
8. Use the pin wrench to tighten the clamping nut securely, then release the arbor lockbutton and remove
the wrench.
5.2 Removing the accessory tool
1. Switch off the power tool.
2. Unplug the supply cord from the power outlet.
3. Press and hold down the arbor lockbutton.
4. Slacken the clamping nut.
5. Release the arbor lockbutton and remove the accessory tool.
18 English
Printed: 14.09.2018 | Doc-Nr: PUB / 5450689 / 000 / 01
)
WA
)
pA
)
pA
)
h
)
h
96.3 dB(A)
3 dB(A)
85.3 dB(A)
3 dB(A)
3.6 m/s²
3.1 m/s²
1.5 m/s²
2207184
*2207184*