Important User Information - 3M Peltor Tactical XP MT1H7F2 Series Bedienungsanleitung

GB
3:2 Switching the headset on and off
Press and hold the On/Off/Mode button for two seconds to switch the headset on or off. A tone will confirm that the unit has
been switched on or off. The last setting is always saved when the headset is switched off, except for the high volume mode on
external input. The headset is automatically powered off after two hours of inactivity. This is indicated by tone signals for the last
minute, then the headset switches off.
3:3 Menu
To browse through the menu, press the On/Off/Mode button briefly. The menu steps are:
Volume, Balance, Equalizer, Release time, External input volume and External input mode.
At each menu step the + (increase) or – (decrease) buttons are used to change the setting.
By pressing and holding the – button for two seconds, some functions can be switched off. To turn back on again, press the +
button briefly. Each step and setting change in the menu is confirmed by a voice message.
3:4 Volume
This volume setting adjusts the level-dependent function for ambient sound in 6 levels and an off mode. The volume is limited to
82 dB. The amplification is reduced when an external signal comes in through the external input.
Note! When this function is switched off the ambient sound will not be attenuated, which could be hazardous.
3:5 Balance
The balance between the right and left ear can be adjusted to 9 different settings. Centre balance can be found by pressing the
+ and – buttons at the same time.
3:6 Equalizer
The Equalizer adjusts the tone and has a choice of four settings: Low, Neutral, High and Extra High.
3:7 Release Time (level-dependent function for ambient sound)
The release time setting adjusts the time before the limiter for the level-dependent function opens after activation. Available
settings are Normal and Slow.
3:8 External Input Mode (headset only)
The external input can be set to one of three modes. Try the three levels until you find the ideal one for your connected device.
3:9 External Input Volume (headset only)
The volume of the external input can be set to normal or high.
WARNING! At the high setting the volume may exceed 82 dB.

4. IMPORTANT USER INFORMATION

It is recommended that the wearer ensures that:
• The ear-muffs are fitted, adjusted and maintained in accordance with the manufacturer's instructions.
• The ear-muffs are worn at all times in noisy surroundings.
• The ear-muffs are regularly inspected for serviceability.
Warning!
If the recommendations above are not adhered to, the protection afforded by the ear-muffs will be severely impaired.
• This product may be adversely affected by certain chemical substances. Further information should be sought from the
manufacturer.
• Ear-muffs, and in particular cushions, may deteriorate with use and should be examined at frequent intervals for cracking and
leakage, for example.
• The fitting of hygiene covers to the cushions may affect the acoustic performance of the ear-muffs.
• This ear-muff is provided with level-dependent attenuation. The wearer should check correct operation before use. If distortion
or failure is detected, the wearer should refer to the manufacturer´s advice for maintenance and replacement of the battery.
• This ear-muff is provided with electrical audio input. The wearer should check correct operation before use. If distortion or
failure is detected, the wearer should refer to the manufacturer's advice.
Follow the advice in this manual on maintaining and replacing batteries.
Warning!
• Performance may deteriorate with battery usage. The typical period of continuous use that can be expected from the ear-muff
battery is 1000 hours.
3