Dmx Mode - HQ Power VDPL3615MHZ Bedienungsanleitung

7.2 Menu Structure
Refer to the menu structure on page 3 of this manual.
7.3 Stand-Alone Mode
Automatic Mode
In automatic mode, the device runs one of the built-in programs.
To set the device to automatic mode:
1. Disconnect the DMX input [4] of the device.
2. In the main menu, select [Auto Mod].
3. Press [Enter] and select the master or slave device.
Sound-Activated Mode
In sound-activated mode, the device reacts to sound, running through the built-in programs.
To set the device to sound-activated mode:
1. Disconnect the DMX input [4] of the device.
2. In the main menu, select [Sund Mod].
3. Press [Enter] and select the master or slave device.
7.4 Master/Slave Mode
The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
1. Connect all devices in series with DMX cables.
2. Choose one device that will function as master device. Set up the unit as described in Stand-Alone
Mode.
The other connected devices will now automatically work in slave mode.
Note: Only one device can serve as a master device.
7.5

DMX Mode

This mode allows you to control the device by any universal DMX controller.

All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.

When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.

In case of the 16-channel mode, you will have to set the start address of the first unit to 1 (CH1-16),
the second to 17 (1 + 16) (CH17-32), the third to 33 (17 + 16) (CH33-48), and so on. The highest
start address is 497.
To set the device to work with a DMX controller:
1. In the main menu, press [DMX Mod].
2. Press [Enter] to return to the main menu and select [DMX Address].
3. Use [Up] and [Down] to set the DMX starting address (001-512) and press [Enter].
DMX Channel Values
channel function
1
2
3
V. 01 – 15/09/2014
from
pan 000
tilt 000
zoom 000
VDPL3615MHZ
to description
255 pan from 0 to 100 %
255 tilt from 0 to 100 %
009 narrow to wide
7 ©Velleman nv