Hangar 9 ASH 31 6.4M Bedienungsanleitung Seite 6

7. Measure and mark the wing panel at the servo hatch; 10mm from
raised outer hatch edge and 45mm from rear raised edge.
When mounting the frame in the wing, the edge of the frame lines
up with the front and back marks, and the servo output lines up
with the 45mm mark.
8. Using epoxy (DLMAD64), install the servo mount to the wing panel.
Ensure the servo arm will align with the surface control horn.
The arm clearance notch should face the wingtip and the servo
lead notch should face forward. Clean any epoxy from the servo
mounting area, which may interfere with the servo fitting into the
mount, with paper towel and alcohol. Allow the epoxy to cure fully.
9. Install anti-rotation pins in the root end with epoxy. Do not push the
pin in past half the length of the pin. Wipe away any excess epoxy
with paper towel and alcohol.
10. Connect a 12" servo lead extension to the aileron servo. Secure the
extension with a servo connector clip (SPMA3054) or heat shrink
tubing.
11. Use either a string with a weight attached or a long plastic pushrod
to thread the assembled servo extension through the wing panel
and out the previously cut access hole.
TIP: Feed the string or plastic rod through the access hole to the
servo hatch and attach the servo lead to the end. Pull the servo
lead end back through the access hole.
EN
12. Install the servo arm. Install the servo in the mount using short
10mm
servo screws (2 x 8mm).
45mm
13. Carefully measure and cut the hole in the hatch for the servo arm
using a rotary tool or hobby knife. Test fit the hatch often to ensure
adequate clearance of the servo arm through full travel of the
servo. Round the outside corners of the hatch to fully fit into the
recessed mounting area of the wing panel.
14. Cut a piece of white UltraTrim (HANU80000) adhesive film about
3 cm larger than the size of the servo hatch.
15. Peel and stick the adhesive film to the finished side of the servo hatch.
TIP: Start at the center of the hatch and carefully press any air
bubbles and wrinkles out of the film as you work your way to the
edges.
Cut and remove the hole for the servo arm. Trim the film to
approximately 10 mm past the edge of the hatch and ease the
corners as shown to help prevent the corners from lifting after use.
16. Carefully install the servo hatch to the wing panel by placing the
hatch in the recess of the wing panel and pressing the film to the
wing panel around the perimeter of the hatch. Work outward from
the hatch to remove any air bubbles or wrinkles.
6