Troubleshooting - auna 10032730 Bedienungsanleitung

TROUBLESHOOTING

The following checks will assist in the correction of most problems which
you may encounter with your set. Before going through the checklist below,
first check the following points.
The power cord must be connected firmly.
Should any problem persist after you have made these checks consult
the customer support.
Problem
RADIO RECEPTION
No radio
reception
CD PLAYER OPERATION
Disc does not play
Or sound skips.
Sound skips.
Unit is not working.
GENERAL
Programmed disc
play will not
function.
No sound output.
Severe hum or noise
on the radio.
Display garbled,
non-functional..
Possible Causes (and Remedies)
The MODE selector has not been set to the correct
position.
Adjust the VOLUME VOL + volume.
Turn the TUNING knob to find a radio station.
Bring the FM antenna into a better position..
Reload the disc with the label side up
Clean the disc.
Change the installation location.
Press the Reset button STANDBY.
Press the STOP button and then program the tracks.
The AC power cord is not connected to an AC wall outlet.
Check that the power cord is connected firmly.
Push the power button from the "OFF" position to "ON".
Continuously press "VOL+" to control the sound level.
Press the Reset button STANDBY.
The TV or VCR is too close to the stereo system.
Move away from the TV or VCR.
Bring the FM antenna into a better position.
Turn off the power to restart.
EN
31