Installation And Operation - Klarstein 10030663 Anschluss- Und Anwendungshinweise

Installation
1. Take out the beer cooler from its package. Place the beer cooler on a steady and horizontal surface, and
make sure the beer cooler is at least 5 inches/10 cm away from other appliances or wall on each side so
as to allow correct ventilation on the appliances to get better performance.
Handle
Faucet
2. Install the tap handle connect the tap, make sure both end fit together perfectly.
3. Set the water drip tray into the notch provided.
4. Plug the beer cooler.
Note: Do not connect or disconnect the electric plug when your hands are wet. Before use it, make
sure the voltage is conformity with plug mark, and check whether the power cord is well connected
or not; if not, please don't use it, and call service center;
5. Put 800ml water into the cooling cavity or pour the water to the max mark (It can work without water,
but it can't display the best performance).
Note: Make sure the drain switch is at "Off" position, and no extra objects in the cooling cavity
The max water
level line

Installation and Operation

Drip tray
24