Extension Cords; Adjustments; Workpiece Hold-Down Adjustments; Turntable Mitre Adjustment - Jet ELITE EVC-400DGSP Bedienungsanleitung

7.2 Extension cords

The use of extension cords is discouraged; try to position
machines near the power source. If an extension cord is
necessary, make sure it is in good condition.
An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating.
Only use extension cords marked H07RN-F, with wires 1,5mm2
or more.
The total length of cord may not exceed 18 Meter
Extension cords and plugs must be free from defects.

8.0 Adjustments

8.1 Workpiece hold-down adjustments

The workpiece hold-down cylinders (K, Figure 8-1) must be
adjusted according to the profile to be clamped.
- For horizontal adjustment loosen lever (M).
- For vertical adjustment loosen lever (P).
After adjusting, confirm the proper workpiece clamping and
make sure the pneumatic cylinders (K) and support arms (N) are
firmly locked in place.
Figure 8-1: Hold-down clamps Adjustment
WARNING:
As requested by CE regulations, the machine is equipped with
double pneumatic clamping.
In order to avoid hand crushing, keep the clamping pad (O)
movement short.
Lower the pneumatic cylinder (K) as much as possible, as
profile to be clamped allows.

8.2 Turntable mitre adjustment

The turntable (C) is equipped with precise mitre indexing for
90° (S, Figure 8-2) and for +/- 45° (Q).
Lift the mitre select handle (R) to rotate the turntable (C).
Figure 8-2: Table Mitre Adjustment

8.3 Saw blade installation

To access the sawblade, operate as follows:
- Turn Main Power Switch OFF (H, Figure 8-3).
- Loosen the screws (T) and remove the sawblade access cover
(G).
Figure 8-3: Sawblade access cover
WARNING:
Make sure the saw blade has stopped before opening the
cover.
10