Radio Operation - Classic Phono TCD-2500 Benutzerhandbuch

RADIO OPERATION

1) Press the POWER button at the front panel to turn the system 'on' and set the volume to a
low level. Press the FM button to select the FM band as desired. The tuner backlight
comes 'on'.
2) Rotate the TUNING control to tune the desired radio station. If you tune to an FM stereo
station, the FM ST. indicator will light and reception will be in stereo. If you tune to a
weaker FM station, the reception will automatically switch to mono.
3) When you finish listening, press the POWER button again to turn the system off. The
POWER indicator and the tuner backlight go 'off'.
ANTENNA INFORMATION
The FM wire antenna is located on the back of the cabinet. If necessary, adjust the position
and direction of this antenna until you find the position that provides the best reception.
CD OPERATION
1) Press the CD/USB button to enter the CD mode; the '---' icon will be shown on the screen.
The unit can play CD, CD-R and CD-RW.
2) Press the OP/CL button to open the CD drawer.
3) Place your disc (MP3 is compatible) in the CD drawer with the label side facing up.
4) Press the OP/CL button again to close the CD drawer. The disc will spin for a few
seconds while the player is reading the disc, then the disc stops spinning and starts to
play the first track of the disc.
5) The MP3 icon will be shown while an MP3 is detected. No icon will be shown when no
MP3 file is detected in the disc.
12