Radio Operation - Classic Phono TCD-2550 Bedienungsanleitung

TO USE THE RADIO
Press the [POWER] button (2) to turn ON the unit;
1.
Select the desired audio source by pressing the [SOURCE] button (7 to 11);
2.
(Please see detailed instructions for each Source in the following chapters);
3.
Adjust the volume with the [VOLUME KNOB] (3) to the desired level;
4.
Press and hold the [POWER] button (2) to turn OFF the unit.
5.
Note: When no sound is produced, the unit will switch OFF automat. after 10 minutes.

RADIO OPERATION

Press the [AM] or [FM] button (7 or 8);
1.
Adjust radio frequency to your desired station by turning the [TUNING KNOB]
2.
(19).
Note: For a better reception FM move the wired antenna (23) around.
For MW reception the signals are picked up through a built-in ferrite antenna. You may
have to orient the unit to obtain the best reception.
TURNTABLE OPERATION
Note: When using the turntable for the first time, turn the [TRANSPORTATION LOCK SCREW]
(26) clockwise until fully screwed in.
Press the [PHONO] button (11);
1.
Place a record on the turntable. Place the EP adapter over the central spindle
2.
when playing 45 rpm records;
Set the [SPEED SELECTOR] (30) to 33, 45 or 78 rpm according to the record;
3.
Release the [TONEARM CLAMP] (28), and remove the stylus protector;
4.
Lift up the [TONEARM] (27) with the [LIFT LEVER] (30);
5.
Move the [TONEARM] (27) to the beginning of the record;
6.
Lift down the [TONEARM] (27) with the [LIFT LEVER] (29);
7.
When the record is finished the [TONEARM] (27) will automatically return to the
8.
rest support and the [PLATE] (25) will stop turning. To stop manually, lift up the
tonearm from the record and return it to the rest support.
NOTE: Do not turn or stop the turntable manually. Moving or jarring the turntable without
securing the tone arm clamp could result in damage to the tone arm.
9