Power Source - Classic Phono TCD-2500 Benutzerhandbuch

POWER SOURCE

This system is designed to operate on normal 230V 50Hz AC only.
Attempting to operate from any other power source may cause damage to the system, and
such damage is not covered by your warranty.
NOTE: If this plug does not fit into your outlet, you probably have an outdated non-polarized
AC outlet. You should have your outlet changed by a qualified licensed electrician.
AC Plug
AC Outlet
IMPORTANT: Raising And Lowering The Phonograph Lid
To open the lid, raise it as far as it will go until the lid support bracket 'locks' in the open
position.To close the lid, lift it upward slightly until the lid support bracket 'unlocks', and then
gently lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID TO CLOSE.
ALAWYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from moving when
you operate the controls. These 'feet' are made from nonmigrating rubber material specially
formulated to avoid leaving any marks or stains on your furniture. However, cartain types of oil
based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet'
to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to
your furniture we strongly recommend that you purchase small self-adhesive felt pads,
available at hardware stores and home improvement centres everywhere, and apply these
pads to the bottom of the rubber'feet' before you place the product on fine wooden furniture.
CARE OF THE CABINETS: You should care for the cabinet as you would care for any piece
of furniture. When the cabinet becomes dirty, wipe it with a soft, non-abrasive dust cloth. If the
cabinet becomes smudged with fingerprints you may use any good quality commercial
dusting and polishing spray cleaner; however avoid spraying the plastic or metal parts of this
system.
We recommend that you spray the cleaner on your dust cloth, not directly on the cabinet, to
avoid getting any of the spray on the plastic or metal parts.
6