Preparation For Use - Classic Phono TCD-2500 Benutzerhandbuch

UNPACKING AND SET UP
Carefully remove the unit from the display carton and remove all packing material from the
•
unit.
Unwind the AC power cord and extend it to its full length.
•
Unwind the FM Antenna wire and extend it to its full length.
•
Place the unit on a stable, level surface, convenient to an AC outlet away from a strong
•
magnetic field.
Connect the plug to your AC outlet.
•
Raise the lid to expose the phonograph. The phonograph has been secured for shipment
•
with a transit screw. Use a coin or screwdriver to turn the transit screw clockwise. This will
allow the turntable to "float".
TRANSIT SCREW
Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it in
•
the direction of the arrow (refer to the picture on the right side).
During this operation pay attention to the stylus, because damage to the stylus is not
•
covered by the guarantee.
Remove the twist-tie that was used to secure the tone arm during shipment.
•
Release the tone arm lock lever (refer to the picture on the right side).
•
Connect the plug to your AC 230V, 50Hz outlet.
•
TONE ARM
LOCK LEVER
STYLUS COVER

PREPARATION FOR USE

5