Specific Safety Rules - BTI PROFILINE -BH 2-26 ME Bedienungsanleitung

f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edg-
es are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool
bits etc., in accordance with these instruc-
tions and in the manner intended for the
particular type of power tool, taking into ac-
count the working conditions and the work
Wear hearing protection. The noise can cause loss
of hearing.
Take protective measures when dust is pro-
duced while working that is detrimental to
health, combustible or explosive. For example:
Some dusts are considered to be carcinogenic. Use
dust/chip extraction and wear a protective mask.
Keep your workplace clean. Material mixtures are
especially dangerous. Light metal dust can burn or ex-
plode.
Do not use the machine with a damaged cable. If
the cable is damaged while working, do not
touch the damaged cable but pull the mains plug.
A damaged cable increases the risk of an electrical
shock.
For machines used outdoors, connect to the
mains using a fault current (FI) protection switch.
Use suitable detectors to find hidden utility lines
or call the local utility company for assistance.
Contact with electric lines can lead to fire or electrical
shock. Damaging a gas line can result in an explosion.
Penetrating a water pipe will cause property damage
or an electrical shock.
1 619 929 704 • (05.06) T

2 SPECIFIC SAFETY RULES

English–2
to be performed. Use of the power tool for op-
erations different from those intended could re-
sult in a hazardous situation.
5) Service
a) Have your power tool serviced by a quali-
fied repair person using only identical re-
placement parts. This will ensure that the safe-
ty of the power tool is maintained.
Always use the auxiliary handle provided with the
machine. The loss of control over the machine can re-
sult in injuries.
Secure the work piece. A work piece clamped with
clamping devices or in a vice is held more securely
than by hand.
Do not work with materials containing asbestos.
Asbestos is considered carcinogenic.
Hold the machine firmly with both hands while
working and provide for secure footing. The ma-
chine is more securely guided with both hands.
Wait until the machine has come to a standstill
before placing it down. The insertion tool can be-
come caught and lead to loss of control over the ma-
chine.
Overload Clutch
If the insertion tool becomes caught or jammed, the
drive to the drill spindle is interrupted. As a result of the
forces that occur, always hold the machine firmly
with both hands and provide for secure footing.